STANDARDS AND INFORMATION DOCUMENTS
Call for Comment on DRAFT AES-16id-xxxx, AES information document for transfer technologies - Stylus dimensions and selection has been published.
The comment period has now closed. No comments were received.
This document was developed by a writing group of the Audio Engineering Society Standards Committee (AESSC) and has been prepared for comment according to AES policies and procedures. It has been brought to the attention of International Electrotechnical Commission Technical Committee 100. Existing international standards relating to the subject of this document were used and referenced throughout its development.
Address comments by E-mail to the AESSC Secretariat at standards-at-aes.org, or by mail to the AESSC Secretariat, Audio Engineering Society, 60 E 42nd St., New York NY 10165, US. E-mail is preferred. Only comments so addressed will be considered. Comments that suggest changes must include proposed wording. Comments must be restricted to this document only. Send comments to other documents separately.
This document will be approved by the AES after any adverse comment received within three months of the publication of this call on www.aes.org/standards has been resolved. All comments will be published on the Web site.
Persons unable to obtain this document from the Web site may request a copy from the secretariat at
Audio Engineering Society Standards Committee
Draft Comments Dept.
Glos GL15 4AA
Because this document is a draft and is subject to change, no portion of it shall be quoted in any publication without the written permission of the AES, and all published references to it must include a prominent warning that the draft will be changed and must not be used as a standard.